The terminal for the connection of the equipment grounding conductor shall not be identified by which of the following:

An automatic cutout or switch shall be placed in the equipment grounding conductor of a premises wiring system if the opening of the cutout or switch ____________ all sources of energy.

Where the conditions of maintenance and supervision ensure that only qualified persons service the installation, one or more insulated conductors in a multiconductor cable, at the time of installation, shall not be permitted to be permanently identified as equipment grounding conductors at each end and at every point where the conductors are accessible, by which of the following means:

Where extensive metal in or on buildings or structures may become energized and is subject to personal contact, adequate bonding and grounding will provide additional _________?

The metal parts of which of the following nonelectrical equipment described in section 250.116 shall be connected to the equipment grounding conductor:

T/F: Normally non-current-carrying metal parts of equipment and enclosures of motor-operated water pumps, including the submersible type, shall be connected to an equipment grounding conductor, regardless of voltage.

Where a submersible pump is used in a metal well casing, The ______________ shall be connected to the pump circuit equipment grounding conductor.

Exposed, normally non-current-carrying metal parts of equipment described in 250.112(A) through (K) shall be connected to an equipment grounding conductor, regardless of voltage, except as permitted in _______ and ___.

Which exception to Article 250.110 requires the equipment to be marked where such a system is employed?

Exposed, normally non-current-carrying metal parts of fixed equipment supplied by or enclosing conductors or components that are likely to become energized shall not be connected to an equipment grounding conductor under which of the following conditions?